@Lucesat ovviamente
@arthur risponde se e quando vuole, non ha obblighi ed in accordo e dipendentemente dai suoi impegni. ( Certo se tu non lo tagghi non leggerà nè ora nè mai...ti ho messo io la tag...ma ricordati!! @nickname e si tagga....ed arriva notifica...)
Detto questo i PVT suoi non sono bloccati i suoi !!! Sono i tuoi messaggi PVT che non sono abilitati è differente !!! Questo perchè non hai una "
membership " attiva , in accordo al
regolamento (
bbmemberships/index.html )
Ho modificato il file imputato dell'errore che lamenti sul swapmanager ( in allegato scompatta il RAR e trovi il file "py" ). Mettilo nella cartella a fianco al vecchio e riavvia il decoder totalmente e prova se va ok!!! Dopo questo non so che dire.... abituati ad usare il dek senza swap-manager...e magari pensa ad un cambio dek con qualcosa di più moderno, recente e prestante!!! Ultimamente questo MEELO+Turbo sta andando molto molto bene!!
Meglio di Zgemma H5 !! vedi qui >>>
viewtopic.php?f=84&t=35286
Saluti.
NB : Ti riporto cmq un post in una discussione nel forum ufficiale della openPli per farti capire che non ha molto senso usare Swap-file ( cmq è descritta la procedura manuale ) a dispetto di quello che tu continui a dire degli giovamenti che "utopicamente" pensi ti possa dare.
Telnet to the STB then:
Make sure the device you want your swapfile on is mounted e.g. like "ls /hdd" or "ls /media/hdd" returns a file list (at least lost&found).
The following assumes adjusting and exisiting swap on /hdd - note that using your hard disk is not a good idea as it will have the disk active a lot of the time, rather use a flash disk.
If you are setting up swap for the first time skip step (1).
1. /sbin/swapoff /hdd/swapfile --- do this only if you are adjusting swapfile size, adjust this to where you have a swapfile at the moment if any
2. /bin/dd if=/dev/zero of= /hdd/swapfile bs=1048576 count=32 -- adjust /hdd to where the device is mounted that you want the swapfile on; adjust count=32 to size of swap in MB
3. /sbin/mkswap /hdd/swapfile
4. /sbin/swapon /hdd/swapfile
If you have a DM800 you should not need a swapfile. If you do, you must have another look at the plugins you are running and consider reducing them. The DM800 has a weak processor and having to use swap will further destabilise the STB. Swap does not improve processor power, it helps when the STB is running out of memory, but it further loads the processor; so if you already suffer from too heavy a load on the processor, swap is a really bad idea.
Swap is really only needed on the older Enigma1 boxes that had very little memory.
Non hai i permessi necessari per visualizzare i file allegati in questo post.